Blog Archive

Tuesday, March 25, 2014

Oil and gas industry loopholes in 7 major environmental laws

The oil and gas industry is exempt from key provisions of seven major federal environmental laws -- allowing practices that would otherwise be illegal. Some exemptions date back decades. Others were adopted as recently as 2005.
While states and tribes have tried to fill the gaps with their own rules and regulations, they vary widely in effectiveness and enforcement. Federal laws provide consistent standards that equally protect all Americans. That's why it's essential to reverse these federal loopholes.
1. The Safe Drinking Water Act (SDWA)
The Safe Drinking Water Act of 1974 was established to protect America's drinking water. It covers waters actually or potentially designated for drinking, whether from above ground or underground sources. http://water.epa.gov/lawsregs/rulesregs/sdwa/index.cfm
The Energy Policy Act of 2005 exempted hydraulic fracturing (fracking) from SDWA oversight, leaving drinking water sources in the 34 oil and gas producing unprotected from the host of toxic chemicals used during fracking. Congress qualified this exemption to regulate diesel fuel additives used during fracking, which requires industry to apply for a SDWA permit if they are using diesel fuel to hydraulically fracture a well.
2. The Clean Air Act (CAA)
The Clean Air Act , adopted in 1970, is the comprehensive federal law that regulates air emissions from area, stationary, and mobile pollution sources. The CAA established limits for major pollution sources called the National Emission Standards for Hazardous Air Pollutants (NEHAPS) . NEHAPS must be met by installing the Maximum Achievable Control Technology (MACT) for each source.
Smaller sources of pollutants that are under common control by a single operator, are located in close proximity to each other, and perform similar functions are considered as one source of emissions. This aggregation allows for the CAA oversight of smaller sources that, when concentrated, may actually be as harmful as larger sources.
Unfortunately, the CAA exempts oil and gas wells, and in some instances pipeline compressors and pump stations, from aggregation. This exemption allows the oil and gas industry -- which often operates many small facilities in one area -- to pollute while largely unregulated by the CAA.
In addition, in 1991 hydrogen sulfide was removed from the list of Hazardous Air Pollutants under the CAA. This elimination has remained despite a 1993 EPA study, Hydrogen Sulfide Air Emissions Associated with the Extraction of Oil and Natural Gas, which clearly concludes that accidental releases of hydrogen sulfide during oil and gas development are a serious air quality concern and pose a great risk to public health. Common symptoms of exposure to low levels of hydrogen sulfide can include headache, skin complications, respiratory problems and system damage, confusion, verbal impairment, and memory loss.
3. Clean Water Act (CWA)
Enacted in 1972 , the Federal Water Pollution Control Act, commonly known as the Clean Water Act, establishes the basic structure for regulating discharges of pollutants into the waters of the United States.
The 2005 Energy Policy Act amended the CWA to redefine sediment as a nonpollutant. This redefinition broadened the existing exemption for stormwater discharges to oil and gas construction. These exemptions leave streams and rivers in high oil and gas areas unprotected from sediment run-off caused by the construction and operation of well pads, pipelines, drill rigs, and other infrastructure.
4. Resource Conservation and Recovery Act (RCRA)
Adopted in 1976, the Resource Conservation and Recovery Act is the principal federal law that governs the disposal of solid and hazardous wastes. The law takes a cradle to grave approach to ensure that wastes are handled properly from the point of creation to transport to disposal.
In 1980, Congress exempted oil field wastes (which includes waste from natural gas production) from RCRA until EPA proved they were a danger to human health and the environment. Rather than do so, EPA eventually ceded authority to regulate these wastes to the states.
This exemption leaves produced water, drilling fluids, and hydraulic fracturing fluids from oil and gas production unregulated under the nation's premier hazardous waste law. This allows unsafe handling of toxic substances, including their conventional transport on roads and treatment in municipal rather than specialized facilities.
5. Comprehensive Environmental Response, Compensation, and Liability Act (CERCLA)
Commonly known as the Superfund law, the Comprehensive Environmental Response, Compensation, and Liability Act of 1980 makes liable those responsible for a spill or release of a hazardous substance into the environment.
Included in the list of hazardous substances under CERCLA are benzene, toluene, ethylbenzene, and xylene (Btex) chemicals found in crude oil and petroleum.
Yet CERCLA exempts these substances from liability requirements if they are found in crude oil and petroleum (which are used in natural gas production). Thus, hazardous chemicals that would otherwise be regulated under CERCLA are immune from the statute. The definition of hazardous substance also excludes natural gas, natural gas liquids, liquefied natural gas, and synthetic gas usable for fuel.
In addition, Superfund allows Potentially Responsible Parties to be held liable for clean-up costs for a release or threatened release of a hazardous substance. But CERCLA defines this term to exclude oil and natural gas. Consequently, industry has little incentive to clean up its hazardous waste, or to minimize leaks and spills, in part because the exemption allows companies to escape liability when these problems occur.
6. National Environmental Policy Act (NEPA)
The National Environmental Policy Act  of 1970 establishes the broad national framework for protecting our environment. NEPA s ensures the federal government gives proper consideration to the environment before undertaking any major federal action (including involvement in industrial projects) that significantly affects the environment.
The Energy Policy Act of 2005 stripped NEPA's strong requirements for public involvement and environmental review when it comes to several oil and gas related activities. It stipulated that they should be analyzed and processed by the Interior and Agricultural Departments under a much narrower and weaker process known as a Environmental Assessment (EA) or Environmental Impact Statement (EIS) required under NEPA. In addition, a CE does not allow for any public comment. In 2006 and 2007, the BLM granted this exemption to about 25 percent of all oil and gas wells approved on public land in the West.
7. The Toxic Release Inventory of EPCRA
The Toxic Release Inventory (TRI) was created by section 313 of the Emergency Planning and Community Right-to-Know Act (EPCRA) of 1986. It requires most industries to report significant of toxic substances to the EPA, which then aggregates and disseminates the information to the public.
The information on chemical use and release includes point and fugitive onsite air releases, water releases, on and off-site land releases, underground injection, transfers to a Publicly Owned Treatment Works (POTW) or waste management facility (including the name and address of the facility), and the use of specific on-site waste treatment and management practices.
But despite their use of toxic chemicals throughout production, oil and gas facilities are not required to report to the TRI. This exemption leaves communities in oil and gas producing areas in the dark about what chemicals are being released -- making it difficult to attribute responsibility and seek remedy for resulting health and environmental problems.

No comments: